Jump to content

Homemade watch hand setters


Dpastl

Recommended Posts

Hey All,

I thought I'd share the plans for making watch hand setters.  I wasn't able to get any cheaply or easily so I decided to make my own.

A note of caution, turning small diameter PVC is a pain.  I was able to after much trial and error, but the accuracy was pretty bad.  To be fair I was using an enormous 13x48" engine lathe with a 3jaw chuck and HSS tools ground for steel so your results may vary.

Design is based on pictures of other watch setters I found on the internet. I chose 0.5mm, 1mm, 1.5mm and blunt tips.

Cheers,

IMG_1136.JPG

Watch Hand Setter Drawing.pdf

  • Like 1
  • Thanks 2
Link to comment
Share on other sites

  • 2 weeks later...
On 4/30/2019 at 6:49 AM, dcronin said:

Dpastl, if you're using that on Rolexes, it is probably good enough for anything I'll get my hands on (no pun intended)!

That is the butt end of a center punch, I'm guessing.

No rolexes haha.  I only have older AS movements for the most part. They work super well, especially in comparison to pegwood with a hole.  That was not great.

Center punch?  They're all custom turned parts as per the plans.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



  • Recently Browsing

    • No registered users viewing this page.
  • Topics

  • Posts

    • That would be something! Which brings me back to;  
    • you think you're going to sleep tonight you're not, you're going to ponder the question of what makes you think those of the right parts?  
    • Does anyone knows what size case a need for a dial diameter 20.60mm?
    • Sounds like the story with my Rolex. Poor (expensive) job done by an official Rolex dealer with an "in-house" watchmaker, hence I learned watchrepair and did the servicing myself. Same story as I learned with the Omega 861, again poor job by an "in-house" watchmaker by an official Omega dealer. Once your watch goes through that back-door, you have no idea what is going to happening to it 🫣   Quite nice that they sent back the parts which had been replaced !
    • yes that's definitely not right at all. I have a picture one of my friends has a Omega coaxial there was having issues to lose asking me where he should send it. As that's a specialty watch I suggested the service center. When he got it back he sent me a picture so the replace the dial as you can see the hands the mainspring barrel and I think the price was really quite decent considering all the stuff they can replace. So I do know they do change the barrels but the other person I worked at the service center when I would ask questions and unfortunately I can't remember all the answers. I think a lot of the changing a parts is at the discretion of the watchmaker. Plus I don't know enough about the chronographs and whether that would be considered a vintage watch? I take some of the vintage watches may have been sent directly to Switzerland or another service center. Obviously with a watch like the one down below they probably have a infinite supply of parts is its relatively modern vintage stuff becomes more interesting even the watch companies don't have necessarily infinite supply of parts. But no matter what the watch shouldn't disintegrated six months that's definitely an issue.        
×
×
  • Create New...