Jump to content

Rolex precision 6466 stop when crown screw down


Recommended Posts

Hello guys

Why my rolex precision 6466 stops when crown screw down..

But it runs again when crown not screw down or in manual wind position?

It stops when the crown enter too deep inside the movement..

Thankyou

Link to comment
Share on other sites

Personally, I've never owned a Rolex but I've experienced this same issue with Seiko divers. There is a rubber seal in the base of the crown and due to age and use, it can become brittle and break, causing it to fall out of the crown in small bits. When this happens, the space previously occupied by the rubber gasket allows the crown to seat further into the watch, thereby interfering with the normal operation. 

You will likely need to remove the stem and crown, install a new crown gasket or o-ring, whichever is required, and all should return to normal. I might add that if the gasket has perished, likely your watch is due or even overdue for a full service.

  • Like 1
Link to comment
Share on other sites



×
×
  • Create New...