Jump to content

What movements other than ETA?


phydaux

Recommended Posts

So in my journey to become fluent with watch repair i have so far focused on ETA movements and their clones.  Specifically the 6498, 2801, 2824, 2892, 2636, and the 7750.  To be honest, I have focused on these movements because they and their clones are readily available on eBay.  

I'm thinking I should add common movements from other companies, for example Seiko and Miyota.  The question becomes, then, what ones?  I want to practice on movements that are common and broadly used, but I also want to be able to buy the naked movement cheaply.

Any recommendations?

Link to comment
Share on other sites

There are loads (and I do mean loads) of cheap, second hand Seiko and Citizen watches on ebay from Indian sellers. The movements are usually "high mileage" and although the sellers often claim the watch to be "fully serviced", the state of these watches vary from pristine, like new,  to frankly filthy. 

So far as practice pieces go, they are ideal, complete with interesting quirks. 

Don't pay more than £10 for one, unless it looks exceptionally good. I added a couple of actually quite nice ones to my "404 collection" (watches picked up on ebay for £4.04 or less). Also look at HMT watches, as they are usually Citizen movements, made under license in India. You can actually pick these up new (or new old stock) from the HMT website or several ebay sellers.

Link to comment
Share on other sites



  • Recently Browsing

    • No registered users viewing this page.
  • Topics

  • Posts

    • Two pins or screwdrivers angled out slightly, pressing through from the barrel centre from the opposite side so they contact just clear of the hole in the lid? eg. Strap pin driver needles or similar.
    • That's a good idea - shrinking down the nut and wrench size from the old casebook trick!
    • I missed this earlier. The dial isn't going into the holder, it should sit proud of it. This is what I am currently using which I print for each different movement.    
    • I didn't think pulling to set position would work harden the spring, in that position it is stressed where the arm starts. By work hardening i meant rapid polishing at that point, a bit like polishing a pivot work hardens as it compresses the steel. I doubt polishing by hand would achieve much in that respect though. Its finished, arm polished up mostly at the join to the bridge's main body. I'm ok with it, the screw holes aren't great as i had to open them up by redrilling and positioning it was difficult, I'm not much use with a loupe, opening up with a file might be a better option for me or i could just use the correct drill size 😅. And the detent is way too deep, i had to guess that with the stem release out of position and sat on top, but i only took one measure and went for it, no slowly slowly catch your monkey 😅. First go I'm happy , well sort of, it works and thats a big thing for me, next one will have a bit more finesse.  Anyone thats interested, after filing, i used a 2000 grade home made diamond  micro file and then 20 micron film, the film is much better than wet and dry, more stable to use and doesn't shed cheap grade grit everywhere , then auto polish on a sponge pad.
    • I'm assuming that every time you set the watch you are work hardening the detent spring, maximum hardening is  where it meets the plate due to maximum deflection.   That's why it snaps there.  The Young's modulus may be the same but after it's reached its maximum yeid strength it breaks.  My mechanic engineering is very rusty, correct me if I'm wrong. 
×
×
  • Create New...