Relax Zone: Chat About Anything Here
Talk about whatever you fancy within the forum rules, not just about watches.
BUT: If you wish to start a topic relating to watch repair then please find the appropriate section here.
SECTION RULES
This section is for those who wish to relax and chit chat about whatever.
BUT PLEASE: Do not post topics here regarding watch repair, you can find an appropriate section for any watch repair topics here. Thank you for your understanding.
621 topics in this forum
-
- 1 reply
- 554 views
-
- 4 replies
- 944 views
-
- 3 replies
- 968 views
-
- 6 replies
- 1.2k views
-
- 0 replies
- 561 views
-
- 4 replies
- 761 views
-
- 2 replies
- 516 views
-
- 5 replies
- 816 views
-
- 0 replies
- 524 views
-
- 7 replies
- 1.3k views
-
- 0 replies
- 1.4k views
-
- 3 replies
- 812 views
-
- 6 replies
- 5.4k views
-
- 4 replies
- 570 views
-
- 13 replies
- 1.6k views
-
- 0 replies
- 631 views
-
- 10 replies
- 1.1k views
-
- 0 replies
- 659 views
-
- 4 replies
- 744 views
-
- 17 replies
- 1.2k views
-
- 2 replies
- 698 views
-
- 0 replies
- 697 views
-
- 39 replies
- 3.6k views
-
- 3 replies
- 712 views
-
- 74 replies
- 15.2k views
-
Topics
-
-
Posts
-
-
By ManSkirtBrew · Posted
Oh really, like my Seiko 6139? When I pulled out the crown it had 3 positions, so I assumed one position set the day/date. I'll check more closely when I put it back together. Thanks again! -
Hello there! I am restoring a dial need to achieve this same finishing. I've bee through most of the jewellers stores, ebay and aliexpress trying to find the wire wheel he used to produce the sunburst finish. Any idea where I could buy this wire wheel? -
One of the reverser wheels came off with the bridge but they are interchangeable. The Bulova tech sheet also has a diagram (attached). I thought your date corrector looked like it was in the correct position. Just to confirm, the quickset works by pulling and then pushing the crown in and out to advance the date. Bulova_11 AOAC, D, B.pdf -
sometimes the barrel bridge is rubbed too, causing more movement, I assume as said above the setting lever is like new? you can get a small chuck to hold it in your Dremel like you said fine abrasive/grit, might be difficult to keep even, good luck anyway......
-
