Jump to content

Chat About Watches & The Industry Here

Discuss anything about watches and the watch industry.

1,242 topics in this forum

  1. Anthony Cousins Letter

    • 97 replies
    • 54,091 views
    • 8 replies
    • 11,474 views
    • 12 replies
    • 51 views
    • 8 replies
    • 111 views
    • 4 replies
    • 107 views
  2. Rotary skeleton wrist watch.

    • 4 replies
    • 45 views
    • 11 replies
    • 78 views
    • 0 replies
    • 34 views
    • 3 replies
    • 62 views
    • 3 replies
    • 54 views
    • 4 replies
    • 88 views
    • 4 replies
    • 73 views
  3. DJMiles

    • 5 replies
    • 60 views
    • 8 replies
    • 124 views
    • 7 replies
    • 85 views
  4. Rolex ref no: 12600 Datejust

    • 11 replies
    • 109 views
    • 9 replies
    • 92 views
    • 13 replies
    • 150 views
    • 1 reply
    • 57 views
    • 4 replies
    • 82 views
    • 11 replies
    • 163 views
    • 10 replies
    • 352 views
  • Recent Topics

  • Posts

    • Further examination revealed the escape wheel to have a bent pivot as shown in the photo. From what I've read in another WRT post, attempts at bending pivots back into position presents a high risk of breakage.
    • Thanks Stuart for the links to Borel and Cousins.  It has been helpful to see what parts are still available for this caliber.   What is the homemade tool you refer to? I have rewound some hairsprings on the 6497 clones I have been working on but  some sources report that it is not good for the mainspring to be wound this way, especially an old one.   Thanks, Jeffrey
    • Yeah definitely feeling some regret as I was getting to the deep innards of the watch, being careful not to inhale the smallest screws, referring to YouTube to try and figure out what I was looking at... The watch came up pretty cheap in my neighbourhood and I couldn't pass it up. I'm not sure it would justify the cost of a professional service though, so here I am
    • I have an omega triple date repair....the issue is that the month wheel is jammed and will not advance....if the date is advanced via one click of the crown it will stop at 31..the only way at this point to advance it to 01 is via the crown while setting the time...now the issue I am having at time with...getting the pressure ring case back off...for some reason on older pieces I have not had an issue...on this one yes!..any advice on how to remove it would be most welcome...there is no where on the  case back indicating where to insert a case knife....my horotec case back remover was no help in this situation either...thanks...
    • Cheers oldhippy beat me to it,  yep as old hippy says that what it does, its cheap aswell, I think I only paid a few quid for my block from cousins, you have to move the brush very fast but nice and light at the same time to get the best results, then peg out all your pivot holes.
×