Introduce Yourself Here
New to the community? We like to know who we are chatting with :)
So why not introduce yourself here first!
4144 topics in this forum
-
- 4 replies
- 969 views
-
- 4 replies
- 594 views
-
- 3 replies
- 968 views
-
- 5 replies
- 955 views
-
- 3 replies
- 1.4k views
-
- 4 replies
- 599 views
-
- 8 replies
- 1.9k views
-
- 1 reply
- 827 views
-
- 4 replies
- 990 views
-
- 6 replies
- 939 views
-
- 8 replies
- 837 views
-
- 4 replies
- 679 views
-
- 1 reply
- 541 views
-
- 5 replies
- 1.2k views
-
- 7 replies
- 1.3k views
-
- 3 replies
- 811 views
-
- 3 replies
- 1.7k views
-
- 28 replies
- 4.4k views
-
- 3 replies
- 1.4k views
-
- 4 replies
- 964 views
-
- 4 replies
- 2k views
-
- 2 replies
- 685 views
-
- 3 replies
- 1.9k views
-
- 1 reply
- 1k views
-
- 3 replies
- 255 views
-
Topics
-
-
Posts
-
By nevenbekriev · Posted
Hi Jon, do You think that relation spring torque - amplitude is linear? I would rather guess that the amplitude should be proportional to the square of the torque. I had once idea to check it, but still haven't. -
By ManSkirtBrew · Posted
I did not. I thought about it, but I had cleaned it in my ultrasonic, and the tech sheet shows lubricating it in place already assembled, so I figured discretion was the better part of valor. Although since I have to depth the jewels anyway, maybe I pull the pinion off to rule it out 100% as part of the problem. Do you know if there's a safe way to do it? I don't want to use a puller because it would push down on the plane of the wheel, and that seems like a Bad Idea. I thought about using a roller table remover, but I don't think I have a hole stake pointy enough to push it down. -
Before putting it back in the case I would fit the hands and use a pin vice on the stem to make sure the hands were in line. -
-
Put the movement in a movement holder and it will be supported as you push down on the setting lever post to release the winding stem. Make sure the post is over the shoulder of the movement holder so what you are pressing down on is supported. As a general rule, hold the movement and not the movement holder. Replace the hands when the movement isn't in the case and support the centre jewel (if it has one) on a hard surface or staking block when replacing the hands to stop the jewel accidentally moving or even coming out. A dedicated movement holder with a central jewel support is even better, but pricey
-
