Jump to content

Watch Repair Tools & Equipment

Discuss watch repair tools and equipment here. Show off your new tools or discuss care and tool maintenance.


1405 topics in this forum

    • 1 reply
    • 196 views
    • 21 replies
    • 600 views
    • 2 replies
    • 127 views
    • 3 replies
    • 146 views
    • 2 replies
    • 176 views
  1. Balance tac

    • 1 reply
    • 174 views
    • 3 replies
    • 191 views
    • 5 replies
    • 195 views
  2. What are they.

    • 6 replies
    • 349 views
    • 100 replies
    • 33.1k views
    • 6 replies
    • 265 views
    • 0 replies
    • 132 views
    • 0 replies
    • 94 views
    • 5 replies
    • 252 views
    • 3 replies
    • 190 views
    • 9 replies
    • 347 views
    • 0 replies
    • 193 views
    • 4 replies
    • 259 views
    • 29 replies
    • 1.1k views
    • 1 reply
    • 159 views
  3. What are these

    • 1 reply
    • 186 views
  4. Lathe parts.

    • 4 replies
    • 239 views
    • 17 replies
    • 1.2k views
    • 14 replies
    • 487 views
    • 2 replies
    • 251 views


  • Recent Topics

  • Posts

    • Yes it can;  perhaps impulse jewel can't enter the fork horn, if the shock has  knocked a pallet jewel out of alighnment or bent a pivot. Remove the two black screws then the automatic device, loosen the cock screw by couple turns, raise the bridge just enough to pass the impulse jewel over the fork so to get impulse jewel inside the horn, tighten cock screw. It will run, however , might get stuck again if pallet jewels have got misaligned or a pivot has got bent.
    • A little uninspiring.  It does run though...kinda.
    • I decided to find a knew winding pinion for my Vulcain.  I see some wear on the one I have.  I have the spec sheet on the Vulcain 120 and identified the part as #1246.  I searched around and found scotchwatch.com had one.  $45.  I really want it, so I bought it.  Meanwhile, I continued my search and found a part with a different part number (410) on Northern Watch & Clock Supplies in the UK.  It was just a couple of pounds, so I bought it. Later I looked at the invoice from scotchwatch.com and see that the part I bought is 1246 (410), so I think the part has two numbers.  Well, we will see when they arrive.  On part cost 20x the other one.  I am not complaining...as I am glad that someone takes the effort to maintain an inventory for budding watchmakers like myself.  I just think it is interesting. Learning new things every day.
    • Thank you for your introduction and welcome to this friendly forum. A nice looking watch you are wearing. 
    • The hairspring is partially blocked from view by the autowinder but looks to be ok.  The balance swings with a puff in one direction but not the other.  Could it be the position for the impulse jewel and fork?
×
×
  • Create New...