Your Walkthroughs and Techniques
Post descriptive walkthroughs of watches you have stripped down and serviced and/or repaired, parts you have made or techniques you wish to share.
This is an interesting section where we post our challenges and how we have over-come them. You can also post walkthroughs and share your techniques.
SECTION RULES
This section is strictly for those posting real step-by-step walkthroughs of actual repair or servicing techniques relating to watch repair and/or horology in general. The idea is that we help each other by describing or sharing our repair techniques, or telling a story of how we have progressed.
If you are not posting step-by-step walkthroughs, such as - you would just like to showcase a completed repair job, then please choose a more appropriate sub-forum for your content. If your post is not deemed to be a legitimate walkthrough then a moderator will move your post to the appropriate section without notice. Thank you for your co-operation.
- You must be a member with at least 10 posts on the forum in order to contribute in this section
365 topics in this forum
-
- 10 replies
- 10.1k views
-
- 20 replies
- 10.1k views
-
- 25 replies
- 10k views
-
- 10 replies
- 9.6k views
-
- 6 replies
- 9.6k views
-
- 16 replies
- 9.6k views
-
- 5 replies
- 9.5k views
-
- 8 replies
- 9.5k views
-
- 13 replies
- 9.5k views
-
- 16 replies
- 9.5k views
-
- 10 replies
- 9.4k views
-
- 20 replies
- 9.3k views
-
- 35 replies
- 9.3k views
-
- 3 replies
- 9.1k views
-
- 11 replies
- 8.9k views
-
- 14 replies
- 8.9k views
-
- 62 replies
- 8.9k views
-
- 6 replies
- 8.9k views
-
- 5 replies
- 8.8k views
-
- 22 replies
- 8.8k views
-
- 4 replies
- 8.6k views
-
- 9 replies
- 8.6k views
-
- 9 replies
- 8.5k views
-
- 28 replies
- 8.4k views
-
- 25 replies
- 8.3k views
-
Topics
-
-
Posts
-
I was just thinking, maybe a better solution for my design would be to have a standard base, and then use insert rings for each movement? This would reduce plastic used and print time as well as storage of the different holders? Something like this: -
-
By rjenkinsgb · Posted
Look carefully at the tube end?? It appears to me to have a fragment thread visible? Either that or a step just away from the end? I can imagine a chamfer, but a step seems odd - but I've never seen the tubes used on these. -
This is a very valid point and a subtlety that I was unaware of until fairly recently, learning all the time, the video below explains this point well:
-
By HectorLooi · Posted
You don't have to use his special tester. Any good multimeter would work.
-
.thumb.png.f90dbf035d35248cb483d466310379d3.png)
