Your Walkthroughs and Techniques
Post descriptive walkthroughs of watches you have stripped down and serviced and/or repaired, parts you have made or techniques you wish to share.
This is an interesting section where we post our challenges and how we have over-come them. You can also post walkthroughs and share your techniques.
SECTION RULES
This section is strictly for those posting real step-by-step walkthroughs of actual repair or servicing techniques relating to watch repair and/or horology in general. The idea is that we help each other by describing or sharing our repair techniques, or telling a story of how we have progressed.
If you are not posting step-by-step walkthroughs, such as - you would just like to showcase a completed repair job, then please choose a more appropriate sub-forum for your content. If your post is not deemed to be a legitimate walkthrough then a moderator will move your post to the appropriate section without notice. Thank you for your co-operation.
- You must be a member with at least 10 posts on the forum in order to contribute in this section
365 topics in this forum
-
- 10 replies
- 279 views
-
- 2 replies
- 891 views
-
- 5 replies
- 1k views
-
- 17 replies
- 750 views
-
- 22 replies
- 1.2k views
-
- 18 replies
- 1.1k views
-
- 1 reply
- 576 views
-
- 0 replies
- 604 views
-
- 0 replies
- 1.5k views
-
- 7 replies
- 1.1k views
-
- 10 replies
- 2.8k views
-
- 18 replies
- 2k views
-
- 5 replies
- 3k views
-
- 0 replies
- 931 views
-
- 8 replies
- 1.8k views
-
- 25 replies
- 5.9k views
-
- 2 replies
- 1.5k views
-
- 0 replies
- 2.8k views
-
- 62 replies
- 8.9k views
-
- 6 replies
- 2.7k views
-
- 4 replies
- 2.3k views
-
- 3 replies
- 4.8k views
-
- 0 replies
- 2.6k views
-
- 0 replies
- 2.6k views
-
- 20 replies
- 10.1k views
.thumb.jpg.cb17a66989f1e796fd4217db2e9ca9df.jpg)
-
Topics
-
-
Posts
-
By KarlvonKoln · Posted
That is a stunning old Sea King you have! And a very cute little furry assistant also. -
By Neverenoughwatches · Posted
No problem with this steel breaking its a perfect working material, the difficult bit is figuring out where to put the detent on the spring. Yessss, at last not a watchmaker but a part maker. Its not perfect, i made 2 mistakes . I made a guess where to put the detent on the spring and i made it a bit too deep and the other was the drill bit caught a wobble on when i tried to open up the post hole 2 tenths. But it works perfectly with a solid click on crown set position so I'm well chuffed. Not sure what to do about harden and tempering it, seems to have a good spring action in its annealed state, do i leave it as is ? -
Thanks.🙏 Very helpful. What a cool and talented and helpful group/community! Well done -- and much appreciated! -
-
By ManSkirtBrew · Posted
Just to wrap it up, here are some shots with that vintage Caravelle strap.
-
